• B168 Earphone Accessory Clip On resin bits mold for handmade resin crafts
  • B168 Earphone Accessory Clip On resin bits mold for handmade resin crafts, alternate view 2
  • B168 Earphone Accessory Clip On resin bits mold for handmade resin crafts, alternate view 3
1 3

margin

b168 earphone accessory clip-on 小配件模具，3D 打印，哑光

b168 earphone accessory clip-on 小配件模具，3D 打印，哑光

$5.00 USD
$5.00 USD
促销 售罄
已含税费。 结账时计算的运费。

This Earphone Accessory Clip-On resin bits mold is designed for casting small decorative pieces shaped like earphone clips and accessories — perfect for adding a tech-cute detail to your resin projects.

  • Mold contains 9 cavities measuring approximately ~1 cm each — ideal for small accent pieces.
  • Best for decorating phone grips, frames, charms, keychains, shaker pieces, and decoden-style accessories.
  • Use a small amount of resin and a toothpick or fine tool to fill the detailed clip areas cleanly.
  • Pair finished bits with simple base molds, glitter, mica powder, UV resin, jump rings, and charm findings.
  • Listing notes: matte, 3D printed.

📋 What to Expect — Please Read Before Purchasing

This mold is 3D printed and has a matte finish. This means:

  • The mold surface will have visible layer lines from the printing process — this is normal and expected, not a defect.
  • Your finished resin cast will pick up the matte texture of the mold. If you want a glossy cast, you can sand and polish the mold cavity or apply a gloss topcoat to your finished piece.
  • As a handmade product, there may be minor imperfections in the surface — small marks, slight asymmetry, or variation between units.
  • The mold finish does not affect the structural integrity or usability of the mold.

For full care instructions, processing times, and what to expect from our molds, please read our Must Read page before purchasing.

Finish

matte

Dimensions

查看完整详细信息

  • Care Instructions

    • The colors of the molds may vary, but typically they will be in light or pastel shades.
    • It is strictly prohibited to use a lighter or torch directly on your molds to remove bubbles, as the heat may cause damage to the molds.
    • Trying to remove bubbles using sharp objects like toothpicks or sticks will leave permanent marks or damages, especially on shiny molds, so it is recommended to use silicone pens instead.
    • Please take note that 3D printed molds have matte finishes and printing textures, lines, and marks may appear on them. For acrylic laser cut blanks, they're bonded together and hand polished by us, so there will be some small scratches/marks/scuffs. Please keep in mind that handmade molds are not perfect. All of these will not impact the out come of your resin work. Doming is necesarry.
    • To clean the molds, you can use tapes to pick up dust and other debris.
    • Before first use, we strongly advise that you check your molds thoroughly. Please be aware that we are not responsible for any mold damages caused after use.